Having a hard time securing your Pectel controller? Worried about it being stolen at a show? Double side tape and velcro only go so far to protect your investment. Unfortunately, that isn't further than the average hand can reach!
These aluminum mounts are riveted down to the mounting panel, and the controller is set in a machined cradle, which then uses two arms screwed down over the edges of the controller. Heat-Transferring silicon is recommended to maximize heat transfer to the base, and rubber pads are used on the arms to prevent damage to the controller housing.
Please note, the difference between Gen-1/2 and 3/4 style mounts is that the plates have different clearance cuts for wiring or panels on the bottom.
Select below if you are mounting an SQ-6 or an SQ-6M/SQ-6M12.
Available Options:
Controller:
